Scrubber 50

No filtration?

Check if the filteration function is switched on in the App.
Check if the float switch of sewage tank is stuck, resulting in failure to trigger filtration.
Check if it is too dirty or damaged to be used.
Check if the water pipe is bent.
Check if the filter parts are dirty or wrong in order.
Check if the filter pump is damaged, leaking, or the power connector is burned.

No water spraying out?

Check if clean water is added to the solution tank.
Check if the water spray button of the tablet is turned on or whether the water volume setting is correct.
Check if the magnetic valve is the cause.
Check if there are bent or squeezed water pipes in the entire waterway-Problems with the pump itself.

Suction squeege cannot be lifted?

Check if the cleaning mode turns off the squeegee.
Check if the state of motor push rod extension is normal: no extension, part of the extension, complete extension.
Check if the wire cable is broken or the buckle falls off and cannot be pulled up.
Check if the motor is faulty and cannot work normally – contact engineers.

Abnormal sound of suction squeegee?

Check if the rubber strip is too close to the ground.
Check if there’s too little or no water spray.
Check if the wheel is damaged and needs to be replaced.
Check if the screws of the water absorption raking are loose.

Water stains left on the ground?

Check if dirt adheres to the rubber strip.
Check if the rubber strip is installed in place.
Check if the height of the rear caster is adjusted in place.